Signed-off-by: Eric Miao <eric.miao@marvell.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

U-Boot puts an image at the load address specified in the uImage
header before jumping to the entry point.

In the CONFIG_ZBOOT_ROM case ZBOOT_ROM_TEXT is the right load
address.

Signed-off-by: Uwe Kleine-König <Uwe.Kleine-Koenig@digi.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

* orion: (26 commits)
  [ARM] Orion: implement power-off method for QNAP TS-109/209
  [ARM] Orion: add support for QNAP TS-109/TS-209
  [ARM] Orion: I2C support
  [I2C] i2c-mv64xxx: Don't set i2c_adapter.retries
  [I2C] Split mv643xx I2C platform support
  [ARM] Orion: enable CONFIG_RTC_DRV_M41T80 for D-Link DNS-323
  [ARM] Orion defconfig
  [ARM] Orion: add support for Orion/MV88F5181 based D-Link DNS-323
  [ARM] Orion: MV88F5181 support bits
  [ARM] Orion: Buffalo/Revogear Kurobox Pro support
  [ARM] OrionNAS RD board support
  [ARM] Orion: support for Marvell Orion-2 (88F5281) Development Board
  [ARM] Orion: common platform setup for Gigabit Ethernet port
  [ARM] Orion: platform device registration for UART, USB and NAND
  [ARM] Orion: system timer support
  [ARM] Orion edge GPIO IRQ support
  [ARM] Orion: IRQ support
  [ARM] Orion: provide GPIO method for enabling hardware assisted blinking
  [ARM] Orion: GPIO support
  [ARM] Orion: programable address map support
  ...

Conflicts:

	arch/arm/Kconfig
	arch/arm/Makefile

Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

The cache replacement policy on the Feroceon core doesn't guarantee
that reading through a linear chunk of memory flushes the entire cache.
This is however what the default method for ARMv5TE cores does.

Although the Feroceon is an ARMv5TE core, it implements the same
cache handling instructions as the ARMv5TEJ cores, and must use it for
proper cache flush.

Signed-off-by: Nicolas Pitre <nico@marvell.com>
Acked-by: Russell King <rmk+kernel@arm.linux.org.uk>

The default ARMv4 method consisting of reading through some memory
area isn't compatible with the cache replacement policy of some
ARMv5TEJ compatible cache implementations.  It is also a bit wasteful
when a dedicated instruction can do the needed work optimally.

It is hard to tell if all ARMv5TEJ cores will support the used CP15
instruction, but at least all those implementations Linux currently
knows about (ARM926 and ARM1026) do support it.

Tested on an OMAP1610 H2 target.

Signed-off-by: Nicolas Pitre <nico@marvell.com>
Tested-by: George G. Davis <gdavis@mvista.com>
Acked-by: Russell King <rmk+kernel@arm.linux.org.uk>

AT91RM9200 needlessly verifies machine-type numbers of
supported / known platforms and overwrites it for unknown
ones. Remove it.

Signed-off-by: Guennadi Liakhovetski <lg@denx.de>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

According to ARM7TDMI Technical Reference Manual (ARM DDI 0210C) writing
to the DCC data write register coproc dest registers are 1 and 0, not 0
and 1.

ARM920T TRM (ARM DDI 0151C) agrees on that.

Cc: Ben Dooks <ben-linux@fluff.org>
Signed-off-by: Uwe Kleine-König <Uwe.Kleine-Koenig@digi.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

* git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuild: (40 commits)
  kbuild: introduce ccflags-y, asflags-y and ldflags-y
  kbuild: enable 'make CPPFLAGS=...' to add additional options to CPP
  kbuild: enable use of AFLAGS and CFLAGS on commandline
  kbuild: enable 'make AFLAGS=...' to add additional options to AS
  kbuild: fix AFLAGS use in h8300 and m68knommu
  kbuild: check for wrong use of CFLAGS
  kbuild: enable 'make CFLAGS=...' to add additional options to CC
  kbuild: fix up CFLAGS usage
  kbuild: make modpost detect unterminated device id lists
  kbuild: call export_report from the Makefile
  kbuild: move Kai Germaschewski to CREDITS
  kconfig/menuconfig: distinguish between selected-by-another options and comments
  kconfig: tristate choices with mixed tristate and boolean values
  include/linux/Kbuild: remove duplicate entries
  kbuild: kill backward compatibility checks
  kbuild: kill EXTRA_ARFLAGS
  kbuild: fix documentation in makefiles.txt
  kbuild: call make once for all targets when O=.. is used
  kbuild: pass -g to assembler under CONFIG_DEBUG_INFO
  kbuild: update _shipped files for kconfig syntax cleanup
  ...

Fix up conflicts in arch/um/sys-{x86_64,i386}/Makefile manually.

The variable CFLAGS is a wellknown variable and the usage by
kbuild may result in unexpected behaviour.
On top of that several people over time has asked for a way to
pass in additional flags to gcc.

This patch replace use of CFLAGS with KBUILD_CFLAGS all over the
tree and enabling one to use:
make CFLAGS=...
to specify additional gcc commandline options.

One usecase is when trying to find gcc bugs but other
use cases has been requested too.

Patch was tested on following architectures:
alpha, arm, i386, x86_64, mips, sparc, sparc64, ia64, m68k

Test was simple to do a defconfig build, apply the patch and check
that nothing got rebuild.

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>

since both u-boot and blob support passing MACH_TYPE_LUBBOCK to the
kernel, it should be quite safe to remove this

Signed-off-by: eric miao <eric.y.miao@gmail.com>
Acked-by: Nicolas Pitre <nico@cam.org>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>