This patch updates all instances of csum_tcpudp_magic and
csum_tcpudp_nofold to reflect the types that are usually used as the source
inputs.  For example the protocol field is populated based on nexthdr which
is actually an unsigned 8 bit value.  The length is usually populated based
on skb->len which is an unsigned integer.

This addresses an issue in which the IPv6 function csum_ipv6_magic was
generating a checksum using the full 32b of skb->len while
csum_tcpudp_magic was only using the lower 16 bits.  As a result we could
run into issues when attempting to adjust the checksum as there was no
protocol agnostic way to update it.

With this change the value is still truncated as many architectures use
"(len + proto) << 8", however this truncation only occurs for values
greater than 16776960 in length and as such is unlikely to occur as we stop
the inner headers at ~64K in size.

I did have to make a few minor changes in the arm, mn10300, nios2, and
score versions of the function in order to support these changes as they
were either using things such as an OR to combine the protocol and length,
or were using ntohs to convert the length which would have truncated the
value.

I also updated a few spots in terms of whitespace and type differences for
the addresses.  Most of this was just to make sure all of the definitions
were in sync going forward.

Signed-off-by: Alexander Duyck <aduyck@mirantis.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

This patch add the SO_CNX_ADVICE socket option (setsockopt only). The
purpose is to allow an application to give feedback to the kernel about
the quality of the network path for a connected socket. The value
argument indicates the type of quality report. For this initial patch
the only supported advice is a value of 1 which indicates "bad path,
please reroute"-- the action taken by the kernel is to call
dst_negative_advice which will attempt to choose a different ECMP route,
reset the TX hash for flow label and UDP source port in encapsulation,
etc.

This facility should be useful for connected UDP sockets where only the
application can provide any feedback about path quality. It could also
be useful for TCP applications that have additional knowledge about the
path outside of the normal TCP control loop.

Signed-off-by: Tom Herbert <tom@herbertland.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

Expose socket options for setting a classic or extended BPF program
for use when selecting sockets in an SO_REUSEPORT group.  These options
can be used on the first socket to belong to a group before bind or
on any socket in the group after bind.

This change includes refactoring of the existing sk_filter code to
allow reuse of the existing BPF filter validation checks.

Signed-off-by: Craig Gallek <kraig@google.com>
Acked-by: Alexei Starovoitov <ast@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

m32r allmodconfig was failing with the error:

  error: implicit declaration of function 'read'

On checking io.h it turned out that 'read' is not defined but 'readb' is
defined and 'ioread8' will then obviously mean 'readb'.

At the same time some of the helper functions ioreadN_rep() and
iowriteN_rep() were missing which also led to the build failure.

Signed-off-by: Sudip Mukherjee <sudip@vectorindia.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

m32r allmodconfig is failing with:

  In file included from ../include/linux/kvm_para.h:4:0,
                   from ../kernel/watchdog.c:26:
  ../include/uapi/linux/kvm_para.h:30:26: fatal error: asm/kvm_para.h: No such file or directory

kvm_para.h was not included in the build.

Signed-off-by: Sudip Mukherjee <sudip@vectorindia.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: Ingo Molnar <mingo@kernel.org>

Pull strscpy string copy function implementation from Chris Metcalf.

Chris sent this during the merge window, but I waffled back and forth on
the pull request, which is why it's going in only now.

The new "strscpy()" function is definitely easier to use and more secure
than either strncpy() or strlcpy(), both of which are horrible nasty
interfaces that have serious and irredeemable problems.

strncpy() has a useless return value, and doesn't NUL-terminate an
overlong result.  To make matters worse, it pads a short result with
zeroes, which is a performance disaster if you have big buffers.

strlcpy(), by contrast, is a mis-designed "fix" for strlcpy(), lacking
the insane NUL padding, but having a differently broken return value
which returns the original length of the source string.  Which means
that it will read characters past the count from the source buffer, and
you have to trust the source to be properly terminated.  It also makes
error handling fragile, since the test for overflow is unnecessarily
subtle.

strscpy() avoids both these problems, guaranteeing the NUL termination
(but not excessive padding) if the destination size wasn't zero, and
making the overflow condition very obvious by returning -E2BIG.  It also
doesn't read past the size of the source, and can thus be used for
untrusted source data too.

So why did I waffle about this for so long?

Every time we introduce a new-and-improved interface, people start doing
these interminable series of trivial conversion patches.

And every time that happens, somebody does some silly mistake, and the
conversion patch to the improved interface actually makes things worse.
Because the patch is mindnumbing and trivial, nobody has the attention
span to look at it carefully, and it's usually done over large swatches
of source code which means that not every conversion gets tested.

So I'm pulling the strscpy() support because it *is* a better interface.
But I will refuse to pull mindless conversion patches.  Use this in
places where it makes sense, but don't do trivial patches to fix things
that aren't actually known to be broken.

* 'strscpy' of git://git.kernel.org/pub/scm/linux/kernel/git/cmetcalf/linux-tile:
  tile: use global strscpy() rather than private copy
  string: provide strscpy()
  Make asm/word-at-a-time.h available on all architectures

This patch makes sure that atomic_{read,set}() are at least
{READ,WRITE}_ONCE().

We already had the 'requirement' that atomic_read() should use
ACCESS_ONCE(), and most archs had this, but a few were lacking.
All are now converted to use READ_ONCE().

And, by a symmetry and general paranoia argument, upgrade atomic_set()
to use WRITE_ONCE().

Signed-off-by: Peter Zijlstra (Intel) <peterz@infradead.org>
Cc: Andrew Morton <akpm@linux-foundation.org>
Cc: Dmitry Vyukov <dvyukov@google.com>
Cc: Linus Torvalds <torvalds@linux-foundation.org>
Cc: Paul E. McKenney <paulmck@linux.vnet.ibm.com>
Cc: Peter Zijlstra <peterz@infradead.org>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: james.hogan@imgtec.com
Cc: linux-kernel@vger.kernel.org
Cc: oleg@redhat.com
Cc: will.deacon@arm.com
Signed-off-by: Ingo Molnar <mingo@kernel.org>

Pull locking and atomic updates from Ingo Molnar:
 "Main changes in this cycle are:

   - Extend atomic primitives with coherent logic op primitives
     (atomic_{or,and,xor}()) and deprecate the old partial APIs
     (atomic_{set,clear}_mask())

     The old ops were incoherent with incompatible signatures across
     architectures and with incomplete support.  Now every architecture
     supports the primitives consistently (by Peter Zijlstra)

   - Generic support for 'relaxed atomics':

       - _acquire/release/relaxed() flavours of xchg(), cmpxchg() and {add,sub}_return()
       - atomic_read_acquire()
       - atomic_set_release()

     This came out of porting qwrlock code to arm64 (by Will Deacon)

   - Clean up the fragile static_key APIs that were causing repeat bugs,
     by introducing a new one:

       DEFINE_STATIC_KEY_TRUE(name);
       DEFINE_STATIC_KEY_FALSE(name);

     which define a key of different types with an initial true/false
     value.

     Then allow:

       static_branch_likely()
       static_branch_unlikely()

     to take a key of either type and emit the right instruction for the
     case.  To be able to know the 'type' of the static key we encode it
     in the jump entry (by Peter Zijlstra)

   - Static key self-tests (by Jason Baron)

   - qrwlock optimizations (by Waiman Long)

   - small futex enhancements (by Davidlohr Bueso)

   - ... and misc other changes"

* 'locking-core-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip: (63 commits)
  jump_label/x86: Work around asm build bug on older/backported GCCs
  locking, ARM, atomics: Define our SMP atomics in terms of _relaxed() operations
  locking, include/llist: Use linux/atomic.h instead of asm/cmpxchg.h
  locking/qrwlock: Make use of _{acquire|release|relaxed}() atomics
  locking/qrwlock: Implement queue_write_unlock() using smp_store_release()
  locking/lockref: Remove homebrew cmpxchg64_relaxed() macro definition
  locking, asm-generic: Add _{relaxed|acquire|release}() variants for 'atomic_long_t'
  locking, asm-generic: Rework atomic-long.h to avoid bulk code duplication
  locking/atomics: Add _{acquire|release|relaxed}() variants of some atomic operations
  locking, compiler.h: Cast away attributes in the WRITE_ONCE() magic
  locking/static_keys: Make verify_keys() static
  jump label, locking/static_keys: Update docs
  locking/static_keys: Provide a selftest
  jump_label: Provide a self-test
  s390/uaccess, locking/static_keys: employ static_branch_likely()
  x86, tsc, locking/static_keys: Employ static_branch_likely()
  locking/static_keys: Add selftest
  locking/static_keys: Add a new static_key interface
  locking/static_keys: Rework update logic
  locking/static_keys: Add static_key_{en,dis}able() helpers
  ...

Signed-off-by: Ingo Molnar <mingo@kernel.org>