Sometimes an extraneous "---help---" follows "help". That is probably a copy&paste error stemming from their inconsistent use. Remove those. Signed-off-by: Lubomir Rintel <lkundrak@v3.sk> Link: https://lkml.kernel.org/r/20190822093126.594013-1-lkundrak@v3.sk Signed-off-by: Stephen Boyd <sboyd@kernel.org>
Pull clk updates from Stephen Boyd: "This round of clk driver and framework updates is heavy on the driver update side. The two main highlights in the core framework are the addition of an bulk clk_get API that handles optional clks and an extra debugfs file that tells the developer about the current parent of a clk. The driver updates are dominated by i.MX in the diffstat, but that is mostly because that SoC has started converting to the clk_hw style of clk registration. The next big update is in the Amlogic meson clk driver that gained some support for audio, cpu, and temperature clks while fixing some PLL issues. Finally, the biggest thing that stands out is the conversion of a large part of the Allwinner sunxi-ng driver to the new clk parent scheme that uses less strings and more pointer comparisons to match clk parents and children up. In general, it looks like we have a lot of little fixes and tweaks here and there to clk data along with the normal addition of a handful of new drivers and a couple new core framework features. Core: - Add a 'clk_parent' file in clk debugfs - Add a clk_bulk_get_optional() API (with devm too) New Drivers: - Support gated clk controller on MIPS based BCM63XX SoCs - Support SiLabs Si5341 and Si5340 chips - Support for CPU clks on Raspberry Pi devices - Audsys clock driver for MediaTek MT8516 SoCs Updates: - Convert a large portion of the Allwinner sunxi-ng driver to new clk parent scheme - Small frequency support for SiLabs Si544 chips - Slow clk support for AT91 SAM9X60 SoCs - Remove dead code in various clk drivers (-Wunused) - Support for Marvell 98DX1135 SoCs - Get duty cycle of generic pwm clks - Improvement in mmc phase calculation and cleanup of some rate defintions - Switch i.MX6 and i.MX7 clock drivers to clk_hw based APIs - Add GPIO, SNVS and GIC clocks for i.MX8 drivers - Mark imx6sx/ul/ull/sll MMDC_P1_IPG and imx8mm DRAM_APB as critical clock - Correct imx7ulp nic1_bus_clk and imx8mm audio_pll2_clk clock setting - Add clks for new Exynos5422 Dynamic Memory Controller driver - Clock definition for Exynos4412 Mali - Add CMM (Color Management Module) clocks on Renesas R-Car H3, M3-N, E3, and D3 - Add TPU (Timer Pulse Unit / PWM) clocks on Renesas RZ/G2M - Support for 32 bit clock IDs in TI's sci-clks for J721e SoCs - TI clock probing done from DT by default instead of firmware - Fix Amlogic Meson mpll fractional part and spread sprectrum issues - Add Amlogic meson8 audio clocks - Add Amlogic g12a temperature sensors clocks - Add Amlogic g12a and g12b cpu clocks - Add TPU (Timer Pulse Unit / PWM) clocks on Renesas R-Car H3, M3-W, and M3-N - Add CMM (Color Management Module) clocks on Renesas R-Car M3-W - Add Clock Domain support on Renesas RZ/N1" * tag 'clk-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/clk/linux: (190 commits) clk: consoldiate the __clk_get_hw() declarations clk: sprd: Add check for return value of sprd_clk_regmap_init() clk: lochnagar: Update DT binding doc to include the primary SPDIF MCLK clk: Add Si5341/Si5340 driver dt-bindings: clock: Add silabs,si5341 clk: clk-si544: Implement small frequency change support clk: add BCM63XX gated clock controller driver devicetree: document the BCM63XX gated clock bindings clk: at91: sckc: use dedicated functions to unregister clock clk: at91: sckc: improve error path for sama5d4 sck registration clk: at91: sckc: remove unnecessary line clk: at91: sckc: improve error path for sam9x5 sck register clk: at91: sckc: add support to free slow clock osclillator clk: at91: sckc: add support to free slow rc oscillator clk: at91: sckc: add support to free slow oscillator clk: rockchip: export HDMIPHY clock on rk3228 clk: rockchip: add watchdog pclk on rk3328 clk: rockchip: add clock id for hdmi_phy special clock on rk3228 clk: rockchip: add clock id for watchdog pclk on rk3328 clk: at91: sckc: add support for SAM9X60 ...
- Support gated clk controller on MIPS based BCM63XX SoCs - Small frequency support for SiLabs Si544 chips - Support SiLabs Si5341 and Si5340 chips * clk-bcm63xx: clk: add BCM63XX gated clock controller driver devicetree: document the BCM63XX gated clock bindings * clk-silabs: clk: Add Si5341/Si5340 driver dt-bindings: clock: Add silabs,si5341 clk: clk-si544: Implement small frequency change support * clk-lochnagar: clk: lochnagar: Update DT binding doc to include the primary SPDIF MCLK clk: lochnagar: Use new parent_data approach to register clock parents * clk-rockchip: clk: rockchip: export HDMIPHY clock on rk3228 clk: rockchip: add watchdog pclk on rk3328 clk: rockchip: add clock id for hdmi_phy special clock on rk3228 clk: rockchip: add clock id for watchdog pclk on rk3328 clk: rockchip: convert pclk_wdt boilerplat to new SGRF_GATE macro clk: rockchip: add a type from SGRF-controlled gate clocks clk: rockchip: Remove 48 MHz PLL rate from rk3288 clk: rockchip: add 1.464GHz cpu-clock rate to rk3228 clk: rockchip: Slightly more accurate math in rockchip_mmc_get_phase() clk: rockchip: Don't yell about bad mmc phases when getting clk: rockchip: Use clk_hw_get_rate() in MMC phase calculation
Adds a driver for the Si5341 and Si5340 chips. The driver does not fully support all features of these chips, but allows the chip to be used without any support from the "clockbuilder pro" software. If the chip is preprogrammed, that is, you bought one with some defaults burned in, or you programmed the NVM in some way, the driver will just take over the current settings and only change them on demand. Otherwise the input must be a fixed XTAL in its most basic configuration (no predividers, no feedback, etc.). The driver supports dynamic changes of multisynth, output dividers and enabling or powering down outputs and multisynths. Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl> [sboyd@kernel.org: Mark some things static, use BIT_ULL for big bits and ULL for big constants] Signed-off-by: Stephen Boyd <sboyd@kernel.org>
RK809 and RK817 are power management IC chips for multimedia products. most of their functions and registers are same, including the clkout funciton. Signed-off-by: Tony Xie <tony.xie@rock-chips.com> Acked-by: Stephen Boyd <sboyd@kernel.org> Signed-off-by: Lee Jones <lee.jones@linaro.org>
ROHM BD70528 is an ultra low power PMIC with similar 32K clk as bd718x7. Only difference (from clk perspective) is register address. Add support for controlling BD70528 clk using bd718x7 driver. Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com> Acked-by: Stephen Boyd <sboyd@kernel.org> Signed-off-by: Lee Jones <lee.jones@linaro.org>
Building COMMON_CLK_XGENE is pointless, unless we're building for an XGENE system. Signed-off-by: Marc Gonzalez <marc.w.gonzalez@free.fr> Signed-off-by: Stephen Boyd <sboyd@kernel.org>
- Support for STM32F769 - Rework AT91 sckc DT bindings - Fix slow RC oscillator issue on sama5d3 - AT91 sam9x60 PMC support - SiFive FU540 PRCI and PLL support * clk-stm32f4: clk: stm32mp1: Add ddrperfm clock clk: stm32: Introduce clocks of STM32F769 board * clk-tegra: clk: tegra: divider: Mark Memory Controller clock as read-only clk: tegra: emc: Replace BUG() with WARN_ONCE() clk: tegra: emc: Fix EMC max-rate clamping clk: tegra: emc: Support multiple RAM codes clk: tegra: emc: Don't enable EMC clock manually clk: tegra124: Remove lock-enable bit from PLLM clk: tegra: Fix PLLM programming on Tegra124+ when PMC overrides divider clk: tegra: Don't enable already enabled PLLs * clk-at91: clk: at91: Mark struct clk_range as const clk: at91: add sam9x60 pmc driver dt-bindings: clk: at91: add bindings for SAM9X60 pmc clk: at91: add sam9x60 PLL driver clk: at91: master: Add sam9x60 support clk: at91: usb: Add sam9x60 support clk: at91: allow configuring generated PCR layout clk: at91: allow configuring peripheral PCR layout clk: at91: sckc: handle different RC startup time clk: at91: modernize sckc binding dt-bindings: clock: at91: new sckc bindings * clk-sifive-fu540: clk: sifive: add a driver for the SiFive FU540 PRCI IP block clk: analogbits: add Wide-Range PLL library dt-bindings: clk: add documentation for the SiFive PRCI driver * clk-spdx: clk: sunxi-ng: Use the correct style for SPDX License Identifier clk: sprd: Use the correct style for SPDX License Identifier clk: renesas: Use the correct style for SPDX License Identifier clk: qcom: Use the correct style for SPDX License Identifier clk: davinci: Use the correct style for SPDX License Identifier clk: actions: Use the correct style for SPDX License Identifier
- Mark UFS clk as critical on Hi-Silicon hi3660 SoCs - Support for Cirrus Logic Lochnagar clks * clk-hisi: clk: hi3660: Mark clk_gate_ufs_subsys as critical * clk-lochnagar: clk: lochnagar: Add support for the Cirrus Logic Lochnagar clk: lochnagar: Add initial binding documentation * clk-allwinner: clk: sunxi-ng: sun5i: Export the MBUS clock clk: sunxi-ng: a83t: Add pll-video0 as parent of csi-mclk clk: sunxi-ng: h6: Allow video & vpu clocks to change parent rate clk: sunxi-ng: h6: Preset hdmi-cec clock parent clk: sunxi: Add Kconfig options clk: sunxi-ng: f1c100s: fix USB PHY gate bit offset clk: sunxi-ng: Allow DE clock to set parent rate * clk-rockchip: clk: rockchip: undo several noc and special clocks as critical on rk3288 clk: rockchip: add a COMPOSITE_DIV_OFFSET clock-type clk: rockchip: Turn on "aclk_dmac1" for suspend on rk3288 clk: rockchip: Limit use of USB PHY clock to USB on rk3288 clk: rockchip: Fix video codec clocks on rk3288 clk: rockchip: Make rkpwm a critical clock on rk3288 clk: rockchip: fix wrong clock definitions for rk3328 * clk-qoriq: clk: qoriq: increase array size of cmux_to_group dt-bindings: qoriq-clock: Add ls1028a chip compatible string clk: qoriq: Add ls1028a clock configuration clk: qoriq: add more PLL divider clocks support dt-bindings: qoriq-clock: add more PLL divider clocks support