In fact the device with chip id 0xD283 is called NCT6126D, and that is
the chip id the Nuvoton code was written for. Correct that name to avoid
confusion, because a NCT6116D in fact exists as well but has another
chip id, and is currently not supported.

The look at the spec also revealed that GPIO group7 in fact has 8 pins,
so correct the pin count in that group as well.

Fixes: d0918a84aff0 ("gpio-f7188x: Add GPIO support for Nuvoton NCT6116")
Reported-by: Xing Tong Wu <xingtong.wu@siemens.com>
Signed-off-by: Henning Schild <henning.schild@siemens.com>
Acked-by: Simon Guinot <simon.guinot@sequanux.org>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

Pull MFD updates from Lee Jones:
 "New Drivers:
   - Add support for  Renesas RZ/G2L MTU3

  New Device Support:
   - Add support for Lenovo Yoga Book X90F to Intel CHT WC
   - Add support for MAX5970 and MAX5978 to Simple MFD (I2C)
   - Add support for Meteor Lake PCH-S LPSS PCI to Intel LPSS PCI
   - Add support for AXP15060 PMIC to X-Powers PMIC collection

  Remove Device Support:
   - Remove support for Samsung 5M8751 and S5M8763 PMIC devices

  New Functionality:
   - Convert deprecated QCOM IRQ Chip to config registers
   - Add support for 32-bit address spaces to Renesas SMUs

  Fix-ups:
   - Make use of APIs / MACROs designed to simplify and demystify
   - Add / improve Device Tree bindings
   - Memory saving struct layout optimisations
   - Remove old / deprecated functionality
   - Factor out unassigned register addresses from ranges
   - Trivial: Spelling fixes, renames and coding style fixes
   - Rid 'defined but not used' warnings
   - Remove ineffective casts and pointer stubs

  Bug Fixes:
   - Fix incorrectly non-inverted mask/unmask IRQs on QCOM platforms
   - Remove MODULE_*() helpers from non-tristate drivers
   - Do not attempt to use out-of-range memory addresses associated with io_base
   - Provide missing export helpers
   - Fix remap bulk read optimisation fallout
   - Fix memory leak issues in error paths"

* tag 'mfd-next-6.4' of git://git.kernel.org/pub/scm/linux/kernel/git/lee/mfd: (88 commits)
  dt-bindings: mfd: ti,j721e-system-controller: Add SoC chip ID
  leds: bd2606mvv: Driver for the Rohm 6 Channel i2c LED driver
  dt-bindings: mfd: qcom,spmi-pmic: Document flash LED controller
  dt-bindings: mfd: x-powers,axp152: Document the AXP15060 variant
  mfd: axp20x: Add support for AXP15060 PMIC
  dt-bindings: mfd: x-powers,axp152: Document the AXP313a variant
  counter: rz-mtu3-cnt: Unlock on error in rz_mtu3_count_ceiling_write()
  dt-bindings: mfd: dlg,da9063: Document voltage monitoring
  dt-bindings: mfd: stm32: Remove unnecessary blank lines
  dt-bindings: mfd: qcom,spmi-pmic: Use generic ADC node name in examples
  dt-bindings: mfd: syscon: Add nuvoton,ma35d1-sys compatible
  MAINTAINERS: Add entries for Renesas RZ/G2L MTU3a counter driver
  counter: Add Renesas RZ/G2L MTU3a counter driver
  Documentation: ABI: sysfs-bus-counter: add cascade_counts_enable and external_input_phase_clock_select
  mfd: Add Renesas RZ/G2L MTU3a core driver
  dt-bindings: timer: Document RZ/G2L MTU3a bindings
  mfd: rsmu_i2c: Convert to i2c's .probe_new() again
  mfd: intel-lpss: Add Intel Meteor Lake PCH-S LPSS PCI IDs
  mfd: dln2: Fix memory leak in dln2_probe()
  mfd: axp20x: Fix axp288 writable-ranges
  ...

This patch implements the GPIO function of Intel USB-I2C/GPIO/SPI adapter
device named "La Jolla Cove Adapter" (LJCA). It communicate with LJCA
GPIO module with specific protocol through interfaces exported by LJCA USB
driver.

Signed-off-by: Ye Xiang <xiang.ye@intel.com>
Signed-off-by: Lee Jones <lee@kernel.org>
Link: https://lore.kernel.org/r/20230225140118.2037220-3-xiang.ye@intel.com

Pull gpio updates from Bartosz Golaszewski:
 "We have some new drivers, significant refactoring of existing intel
  platforms, lots of improvements all around, mass conversion to using
  immutable irqchips by drivers that had not been converted individually
  yet and some changes in the core library code.

  Summary:

  New drivers:
   - add a driver for the Loongson GPIO controller
   - add a driver for the fxl6408 I2C GPIO expander
   - add a GPIO module containing code common for Intel Elkhart Lake and
     Merrifield platforms
   - add a driver for the Intel Elkhart Lake platform reusing the code
     from the intel tangier library

  GPIOLIB core:
   - GPIO ACPI improvements
   - simplify gpiochip_add_data_with_keys() fwnode handling
   - cleanup header inclusions (remove unneeded ones, order the rest
     alphabetically)
   - remove duplicate code (reuse krealloc() instead of open-coding it,
     drop a duplicated check in gpiod_find_and_request())
   - reshuffle the code to remove unnecessary forward declarations
   - coding style cleanups and improvements
   - add a helper for accessing device fwnodes
   - small updates in docs

  Driver improvements:
   - convert all remaining GPIO irqchip drivers to using immutable
     irqchips
   - drop unnecessary of_match_ptr() macro expansions
   - shrink the code in gpio-merrifield significantly by reusing the
     code from gpio-tangier + minor tweaks to the driver code
   - remove MODULE_LICENSE() from drivers that can only be built-in
   - add device-tree support to gpio-loongson1
   - use new regmap features in gpio-104-dio-48e and gpio-pcie-idio-24
   - minor tweaks and fixes to gpio-xra1403, gpio-sim, gpio-tegra194,
     gpio-omap, gpio-aspeed, gpio-raspberrypi-exp
   - shrink code in gpio-ich and gpio-pxa
   - Kconfig tweak for gpio-pmic-eic-sprd"

* tag 'gpio-updates-for-v6.4' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux: (99 commits)
  gpio: gpiolib: Simplify gpiochip_add_data_with_key() fwnode
  gpiolib: Add gpiochip_set_data() helper
  gpiolib: Move gpiochip_get_data() higher in the code
  gpiolib: Check array_info for NULL only once in gpiod_get_array()
  gpiolib: Replace open coded krealloc()
  gpiolib: acpi: Add a ignore wakeup quirk for Clevo NL5xNU
  gpiolib: acpi: Move ACPI device NULL check to acpi_get_driver_gpio_data()
  gpiolib: acpi: use the fwnode in acpi_gpiochip_find()
  gpio: mm-lantiq: Fix typo in the newly added header filename
  sh: mach-x3proto: Add missing #include <linux/gpio/driver.h>
  powerpc/40x: Add missing select OF_GPIO_MM_GPIOCHIP
  gpio: xlp: Convert to immutable irq_chip
  gpio: xilinx: Convert to immutable irq_chip
  gpio: xgs-iproc: Convert to immutable irq_chip
  gpio: visconti: Convert to immutable irq_chip
  gpio: tqmx86: Convert to immutable irq_chip
  gpio: thunderx: Convert to immutable irq_chip
  gpio: stmpe: Convert to immutable irq_chip
  gpio: siox: Convert to immutable irq_chip
  gpio: rda: Convert to immutable irq_chip
  ...

intel-gpio for v6.4-2

* Fixed suspend issue on Clevo NL5xNU
* Split a new Intel Tangier (library) driver for current and new platforms
* Introduced a new driver for Intel Elkhart Lake PSE GPIO (see also above)
* Contained a few fixes for the previous of_gpio.h cleanup
* Miscellaneous cleanups here and there

The following is an automated git shortlog grouped by driver:

elkhartlake:
 -  Introduce Intel Elkhart Lake PSE GPIO

gpiolib:
 -  acpi: Add a ignore wakeup quirk for Clevo NL5xNU
 -  acpi: Move ACPI device NULL check to acpi_get_driver_gpio_data()
 -  acpi: use the fwnode in acpi_gpiochip_find()

ich:
 -  Use devm_gpiochip_add_data() to simplify remove path

merrifield:
 -  Utilise temporary variable for struct device
 -  Use dev_err_probe()
 -  Adapt to Intel Tangier GPIO driver

mips:
 -  ar7: include linux/gpio/driver.h

mm-lantiq:
 -  Fix typo in the newly added header filename

powerpc/40x:
 -  Add missing select OF_GPIO_MM_GPIOCHIP

sh:
 -  mach-x3proto: Add missing #include <linux/gpio/driver.h>

tangier:
 -  Introduce Intel Tangier GPIO driver

Add minimal driver for Fairchild FXL6408 8-bit I2C-controlled GPIO expander
using the generic regmap based GPIO driver (GPIO_REGMAP).

The driver implements setting the GPIO direction, reading inputs
and writing outputs.

In addition to that the FXL6408 has the following functionalities:
- allows to monitor input ports for data transitions with an interrupt pin
- all inputs can be configured with pull-up or pull-down resistors

Datasheet: https://www.onsemi.com/download/data-sheet/pdf/fxl6408-d.pdf
Signed-off-by: Emanuele Ghidoli <emanuele.ghidoli@toradex.com>
Co-developed-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
[Bartosz: order includes alphabetically]
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

WARNING: unmet direct dependencies detected for OF_GPIO
  Depends on [n]: GPIOLIB [=y] && OF [=n] && HAS_IOMEM [=y]
  Selected by [y]:
  - GPIO_LOONGSON_64BIT [=y] && GPIOLIB [=y] && HAS_IOMEM [=y] && (LOONGARCH || COMPILE_TEST [=y])

Signed-off-by: Yinbo Zhu <zhuyinbo@loongson.cn>
Reported-by: kernel test robot <lkp@intel.com>
Link: https://lore.kernel.org/oe-kbuild-all/202303091728.UUe6LWye-lkp@intel.com
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

intel-gpio for v6.4-1

* Remove some of the legacy APIs that are not used anymore
* Clean up headers in the GPIO library and drivers

The following is an automated git shortlog grouped by driver:

aggregator:
 -  Add missing header(s)

ARM:
 -  s3c64xx: Use the right include
 -  orion/gpio: Use the right include

gpiolib:
 -  Clean up headers
 -  Group forward declarations in consumer.h
 -  Deduplicate forward declarations in consumer.h
 -  Drop unused forward declaration from driver.h
 -  split of_mm_gpio_chip out of linux/of_gpio.h
 -  split linux/gpio/driver.h out of linux/gpio.h
 -  remove legacy gpio_export()
 -  remove gpio_set_debounce()
 -  remove asm-generic/gpio.h
 -  coldfire: remove custom asm/gpio.h
 -  remove empty asm/gpio.h files
 -  Make the legacy <linux/gpio.h> consumer-only

hte:
 -  tegra-194: Use proper includes

reg:
 -  Add missing header(s)

regmap:
 -  Add missing header(s)

This driver adds support for Intel Elkhart Lake PSE GPIO controller,
using Intel Tangier as a library driver.

Signed-off-by: Pandith N <pandith.n@intel.com>
Co-developed-by: Raag Jadav <raag.jadav@intel.com>
Signed-off-by: Raag Jadav <raag.jadav@intel.com>
Co-developed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>

Make use of Intel Tangier GPIO as a library driver for Merrifield.

Signed-off-by: Pandith N <pandith.n@intel.com>
Co-developed-by: Raag Jadav <raag.jadav@intel.com>
Signed-off-by: Raag Jadav <raag.jadav@intel.com>
Co-developed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>