The loopback test mode is not implemented in all
NS16550 compatible UARTs. The 8250 driver uses the
UPF_SKIP_TEST flag to indicate this, however it is
not possible to set this flag via device-tree.

Add a new 'no-loopback-test' property, and modify
the of_serial driver to set the UPF_SKIP_TEST flag
if the property is present.

Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

This resolves the differences between the original 8250 patch, the revised 8250 patch
and the independant clean up of the octeon driver (to use platform devices properly yay!)

Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

This patch adds a "compatible" string for the new 8250 UART type PORT_LPC3220.
This is necessary for initializing LPC32xx UARTs via DT.

Signed-off-by: Roland Stigge <stigge@antcom.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

The "KT" serial port has another use case for a "received break" quirk,
so before adding another special case to the 8250 core take this
opportunity to push such quirks out of the core and into a uart_port op.

Stephen says:
"If the callback function is to no longer live in 8250.c itself,
 arch/arm/mach-tegra/devices.c isn't logically a good place to put it,
 and that file will be going away once we get rid of all the board files
 and move solely to device tree."

...so since 8250_pci.c houses all the quirks for pci serial devices this
quirk is similarly housed in of_serial.c.  Once the open firmware
conversion completes the infrastructure details
(include/linux/of_serial.h, and the export) can all be removed to make
this self contained to of_serial.c.

Cc: Nhan H Mai <nhan.h.mai@intel.com>
Cc: Colin Cross <ccross@android.com>
Cc: Olof Johansson <olof@lixom.net>
[stephen: kill CONFIG_SERIAL_TEGRA in favor just using CONFIG_ARCH_TEGRA]
Cc: Grant Likely <grant.likely@secretlab.ca>
Acked-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Sudhakar Mamillapalli <sudhakar@fb.com>
Reported-by: Alan Cox <alan@lxorguk.ukuu.org.uk>
Acked-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Dan Williams <dan.j.williams@intel.com>
Acked-by: Stephen Warren <swarren@wwwdotorg.org>
Tested-by: Stephen Warren <swarren@wwwdotorg.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

For simple modules that contain a single platform_driver without any
additional setup code then ends up being a block of duplicated
boilerplate.  This patch adds a new macro, module_platform_driver(),
which replaces the module_init()/module_exit() registrations with
template functions.

Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Acked-by: Greg Kroah-Hartman <gregkh@suse.de>
Reviewed-by: Magnus Damm <magnus.damm@gmail.com>
Reviewed-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Reviewed-by: Stephen Boyd <sboyd@codeaurora.org>

Acked-by: Greg Kroah-Hartman <gregkh@suse.de>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

Simplifies the code a bit and drops a few lines.

Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
Acked-by: Arnd Bergmann <arnd@arndb.de>

Some platforms e.g. TI Davinci require 32-bit accesses to the UARTs.
The of_serial driver currently registers all UARTs as UPIO_MEM.  Add a
new attribute "reg-io-width" to allow the port to be registered with
different IO width requirements.

Acked-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Jamie Iles <jamie@jamieiles.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

Commit b826291c, "drivercore/dt: add a match table pointer to struct
device" added an of_match pointer to struct device to cache the
of_match_table entry discovered at driver match time.  This was unsafe
because matching is not an atomic operation with probing a driver.  If
two or more drivers are attempted to be matched to a driver at the
same time, then the cached matching entry pointer could get
overwritten.

This patch reverts the of_match cache pointer and reworks all users to
call of_match_device() directly instead.

Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

* 'devicetree/next' of git://git.secretlab.ca/git/linux-2.6: (21 commits)
  tty: serial: altera_jtaguart: Add device tree support
  tty: serial: altera_uart: Add devicetree support
  dt: eliminate of_platform_driver shim code
  dt: Eliminate of_platform_{,un}register_driver
  dt/serial: Eliminate users of of_platform_{,un}register_driver
  dt/usb: Eliminate users of of_platform_{,un}register_driver
  dt/video: Eliminate users of of_platform_{,un}register_driver
  dt/net: Eliminate users of of_platform_{,un}register_driver
  dt/sound: Eliminate users of of_platform_{,un}register_driver
  dt/spi: Eliminate users of of_platform_{,un}register_driver
  dt: uartlite: merge platform and of_platform driver bindings
  dt: xilinx_hwicap: merge platform and of_platform driver bindings
  ipmi: convert OF driver to platform driver
  leds/leds-gpio: merge platform_driver with of_platform_driver
  dt/sparc: Eliminate users of of_platform_{,un}register_driver
  dt/powerpc: Eliminate users of of_platform_{,un}register_driver
  dt/powerpc: move of_bus_type infrastructure to ibmebus
  drivercore/dt: add a match table pointer to struct device
  dt: Typo fix.
  altera_ps2: Add devicetree support
  ...