linux.git/kernel/power, branch v4.16.13

x86/power: Fix swsusp_arch_resume prototype

2018-02-02T22:33:50+00:00

The declaration for swsusp_arch_resume marks it as 'asmlinkage', but the
definition in x86-32 does not, and it fails to include the header with the
declaration. This leads to a warning when building with
link-time-optimizations:

kernel/power/power.h:108:23: error: type of 'swsusp_arch_resume' does not match original declaration [-Werror=lto-type-mismatch]
 extern asmlinkage int swsusp_arch_resume(void);
                       ^
arch/x86/power/hibernate_32.c:148:0: note: 'swsusp_arch_resume' was previously declared here
 int swsusp_arch_resume(void)

This moves the declaration into a globally visible header file and fixes up
both x86 definitions to match it.

Signed-off-by: Arnd Bergmann 
Signed-off-by: Thomas Gleixner 
Cc: Len Brown 
Cc: Andi Kleen 
Cc: Nicolas Pitre 
Cc: linux-pm@vger.kernel.org
Cc: "Rafael J. Wysocki" 
Cc: Pavel Machek 
Cc: Bart Van Assche 
Link: https://lkml.kernel.org/r/20180202145634.200291-2-arnd@arndb.de

Merge branch 'for-4.16/block' of git://git.kernel.dk/linux-block

2018-01-29T19:51:49+00:00

Pull block updates from Jens Axboe:
 "This is the main pull request for block IO related changes for the
  4.16 kernel. Nothing major in this pull request, but a good amount of
  improvements and fixes all over the map. This contains:

   - BFQ improvements, fixes, and cleanups from Angelo, Chiara, and
     Paolo.

   - Support for SMR zones for deadline and mq-deadline from Damien and
     Christoph.

   - Set of fixes for bcache by way of Michael Lyle, including fixes
     from himself, Kent, Rui, Tang, and Coly.

   - Series from Matias for lightnvm with fixes from Hans Holmberg,
     Javier, and Matias. Mostly centered around pblk, and the removing
     rrpc 1.2 in preparation for supporting 2.0.

   - A couple of NVMe pull requests from Christoph. Nothing major in
     here, just fixes and cleanups, and support for command tracing from
     Johannes.

   - Support for blk-throttle for tracking reads and writes separately.
     From Joseph Qi. A few cleanups/fixes also for blk-throttle from
     Weiping.

   - Series from Mike Snitzer that enables dm to register its queue more
     logically, something that's alwways been problematic on dm since
     it's a stacked device.

   - Series from Ming cleaning up some of the bio accessor use, in
     preparation for supporting multipage bvecs.

   - Various fixes from Ming closing up holes around queue mapping and
     quiescing.

   - BSD partition fix from Richard Narron, fixing a problem where we
     can't mount newer (10/11) FreeBSD partitions.

   - Series from Tejun reworking blk-mq timeout handling. The previous
     scheme relied on atomic bits, but it had races where we would think
     a request had timed out if it to reused at the wrong time.

   - null_blk now supports faking timeouts, to enable us to better
     exercise and test that functionality separately. From me.

   - Kill the separate atomic poll bit in the request struct. After
     this, we don't use the atomic bits on blk-mq anymore at all. From
     me.

   - sgl_alloc/free helpers from Bart.

   - Heavily contended tag case scalability improvement from me.

   - Various little fixes and cleanups from Arnd, Bart, Corentin,
     Douglas, Eryu, Goldwyn, and myself"

* 'for-4.16/block' of git://git.kernel.dk/linux-block: (186 commits)
  block: remove smart1,2.h
  nvme: add tracepoint for nvme_complete_rq
  nvme: add tracepoint for nvme_setup_cmd
  nvme-pci: introduce RECONNECTING state to mark initializing procedure
  nvme-rdma: remove redundant boolean for inline_data
  nvme: don't free uuid pointer before printing it
  nvme-pci: Suspend queues after deleting them
  bsg: use pr_debug instead of hand crafted macros
  blk-mq-debugfs: don't allow write on attributes with seq_operations set
  nvme-pci: Fix queue double allocations
  block: Set BIO_TRACE_COMPLETION on new bio during split
  blk-throttle: use queue_is_rq_based
  block: Remove kblockd_schedule_delayed_work{,_on}()
  blk-mq: Avoid that blk_mq_delay_run_hw_queue() introduces unintended delays
  blk-mq: Rename blk_mq_request_direct_issue() into blk_mq_request_issue_directly()
  lib/scatterlist: Fix chaining support in sgl_alloc_order()
  blk-throttle: track read and write request individually
  block: add bdev_read_only() checks to common helpers
  block: fail op_is_write() requests to read-only partitions
  blk-throttle: export io_serviced_recursive, io_service_bytes_recursive
  ...

PM / hibernate: Drop unused parameter of enough_swap

2018-01-17T11:41:22+00:00

Parameter flags is no longer used, remove it.

Signed-off-by: Kyungsik Lee 
Signed-off-by: Rafael J. Wysocki

PM / sleep: Make lock/unlock_system_sleep() available to kernel modules

2018-01-10T00:07:46+00:00

Since pm_mutex is not exported using lock/unlock_system_sleep() from
inside a kernel module causes a "pm_mutex undefined" linker error.
Hence move lock/unlock_system_sleep() into kernel/power/main.c and
export these.

Signed-off-by: Bart Van Assche 
Signed-off-by: Rafael J. Wysocki

block: convert to bio_first_bvec_all & bio_first_page_all

2018-01-06T16:18:00+00:00

This patch converts to bio_first_bvec_all() & bio_first_page_all() for
retrieving the 1st bvec/page, and prepares for supporting multipage bvec.

Signed-off-by: Ming Lei 
Signed-off-by: Jens Axboe

PM: hibernate: Do not subtract NR_FILE_MAPPED in minimum_image_size()

2018-01-05T13:46:25+00:00

s2disk/s2both may fail unnecessarily and erratically if NR_FILE_MAPPED
is high - for instance when using VMs with VirtualBox and perhaps VMware
Player. In those situations s2disk becomes unreliable and therefore
unusable.

A typical scenario is: user issues a s2disk and it fails. User issues
a second s2disk immediately after that and it succeeds.  And user
wonders why.

The problem is caused by minimum_image_size() in snapshot.c.  The
value it returns is roughly 100% too high because NR_FILE_MAPPED is
subtracted in its calculation.  Eventually the number of preallocated
image pages is falsely too low.

This doesn't matter as long as NR_FILE_MAPPED-values are in a normal
range or in 32bit-environments as the code allows for allocation of
additional pages from highmem.

But with the high values generated by VirtualBox-VMs (a 2-GB-VM causes
NR_FILE_MAPPED go up by 2 GB) it may lead to failure in 64bit-systems.

Not subtracting NR_FILE_MAPPED in minimum_image_size() solves the
problem.

I've done at least hundreds of successful s2both/s2disk now on an
x86_64 system (with and without VirtualBox) which gives me some
confidence that this is right.  It has turned s2disk/s2both from
unusable into 100% reliable.

Link: https://bugzilla.kernel.org/show_bug.cgi?id=97201
Signed-off-by: Rainer Fiebig 
Signed-off-by: Rafael J. Wysocki

mm: remove __GFP_COLD

2017-11-16T02:21:06+00:00

As the page free path makes no distinction between cache hot and cold
pages, there is no real useful ordering of pages in the free list that
allocation requests can take advantage of.  Juding from the users of
__GFP_COLD, it is likely that a number of them are the result of copying
other sites instead of actually measuring the impact.  Remove the
__GFP_COLD parameter which simplifies a number of paths in the page
allocator.

This is potentially controversial but bear in mind that the size of the
per-cpu pagelists versus modern cache sizes means that the whole per-cpu
list can often fit in the L3 cache.  Hence, there is only a potential
benefit for microbenchmarks that alloc/free pages in a tight loop.  It's
even worse when THP is taken into account which has little or no chance
of getting a cache-hot page as the per-cpu list is bypassed and the
zeroing of multiple pages will thrash the cache anyway.

The truncate microbenchmarks are not shown as this patch affects the
allocation path and not the free path.  A page fault microbenchmark was
tested but it showed no sigificant difference which is not surprising
given that the __GFP_COLD branches are a miniscule percentage of the
fault path.

Link: http://lkml.kernel.org/r/20171018075952.10627-9-mgorman@techsingularity.net
Signed-off-by: Mel Gorman 
Acked-by: Vlastimil Babka 
Cc: Andi Kleen 
Cc: Dave Chinner 
Cc: Dave Hansen 
Cc: Jan Kara 
Cc: Johannes Weiner 
Signed-off-by: Andrew Morton 
Signed-off-by: Linus Torvalds

Merge branch 'pm-sleep'

2017-11-13T00:41:20+00:00

* pm-sleep:
  freezer: Fix typo in freezable_schedule_timeout() comment
  PM / s2idle: Clear the events_check_enabled flag
  PM / sleep: Remove pm_complete_with_resume_check()
  PM: ARM: locomo: Drop suspend and resume bus type callbacks
  PM: Use a more common logging style
  PM: Document rules on using pm_runtime_resume() in system suspend callbacks

Merge branches 'pm-cpufreq-sched' and 'pm-opp'

2017-11-13T00:40:52+00:00

* pm-cpufreq-sched:
  cpufreq: schedutil: Reset cached_raw_freq when not in sync with next_freq

* pm-opp:
  PM / OPP: Add dev_pm_opp_{un}register_get_pstate_helper()
  PM / OPP: Support updating performance state of device's power domain
  PM / OPP: add missing of_node_put() for of_get_cpu_node()
  PM / OPP: Rename dev_pm_opp_register_put_opp_helper()
  PM / OPP: Add missing of_node_put(np)
  PM / OPP: Move error message to debug level
  PM / OPP: Use snprintf() to avoid kasprintf() and kfree()
  PM / OPP: Move the OPP directory out of power/

PM / s2idle: Clear the events_check_enabled flag

2017-11-08T22:52:02+00:00

Problem: This flag does not get cleared currently in the suspend or
resume path in the following cases:

 * In case some driver's suspend routine returns an error.
 * Successful s2idle case
 * etc?

Why is this a problem: What happens is that the next suspend attempt
could fail even though the user did not enable the flag by writing to
/sys/power/wakeup_count. This is 1 use case how the issue can be seen
(but similar use case with driver suspend failure can be thought of):

 1. Read /sys/power/wakeup_count
 2. echo count > /sys/power/wakeup_count
 3. echo freeze > /sys/power/wakeup_count
 4. Let the system suspend, and wakeup the system using some wake source
    that calls pm_wakeup_event() e.g. power button or something.
 5. Note that the combined wakeup count would be incremented due
    to the pm_wakeup_event() in the resume path.
 6. After resuming the events_check_enabled flag is still set.

At this point if the user attempts to freeze again (without writing to
/sys/power/wakeup_count), the suspend would fail even though there has
been no wake event since the past resume.

Address that by clearing the flag just before a resume is completed,
so that it is always cleared for the corner cases mentioned above.

Signed-off-by: Rajat Jain 
Acked-by: Pavel Machek 
Signed-off-by: Rafael J. Wysocki