[ Upstream commit b7405dcf7385445e10821777143f18c3ce20fa04 ]

bond_header_parse() can loop if a stack of two bonding devices is setup,
because skb->dev always points to the hierarchy top.

Add new "const struct net_device *dev" parameter to
(struct header_ops)->parse() method to make sure the recursion
is bounded, and that the final leaf parse method is called.

Fixes: 950803f72547 ("bonding: fix type confusion in bond_setup_by_slave()")
Signed-off-by: Eric Dumazet <edumazet@google.com>
Reviewed-by: Jiayuan Chen <jiayuan.chen@shopee.com>
Tested-by: Jiayuan Chen <jiayuan.chen@shopee.com>
Cc: Jay Vosburgh <jv@jvosburgh.net>
Cc: Andrew Lunn <andrew+netdev@lunn.ch>
Link: https://patch.msgid.link/20260315104152.1436867-1-edumazet@google.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

[ Upstream commit d2d3f529e7b6ff2aa432b16a2317126621c28058 ]

A lot of modern SoC have the ability to store MAC addresses in their
NVMEM. So extend the generic function device_get_mac_address() to
obtain the MAC address from an nvmem cell named 'mac-address' in
case there is no firmware node which contains the MAC address directly.

Signed-off-by: Stefan Wahren <wahrenst@gmx.net>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Link: https://patch.msgid.link/20250912140332.35395-3-wahrenst@gmx.net
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>

When running Cilium connectivity test suite with netkit in L2 mode, we
found that compared to tcx a few tests were failing which pushed traffic
into an L7 proxy sitting in host namespace. The problem in particular is
around the invocation of eth_type_trans() in netkit.

In case of tcx, this is run before the tcx ingress is triggered inside
host namespace and thus if the BPF program uses the bpf_skb_change_type()
helper the newly set type is retained. However, in case of netkit, the
late eth_type_trans() invocation overrides the earlier decision from the
BPF program which eventually leads to the test failure.

Instead of eth_type_trans(), split out the relevant parts, meaning, reset
of mac header and call to eth_skb_pkt_type() before the BPF program is run
in order to have the same behavior as with tcx, and refactor a small helper
called eth_skb_pull_mac() which is run in case it's passed up the stack
where the mac header must be pulled. With this all connectivity tests pass.

Fixes: 35dfaad7188c ("netkit, bpf: Add bpf programmable net device")
Signed-off-by: Daniel Borkmann <daniel@iogearbox.net>
Acked-by: Nikolay Aleksandrov <razor@blackwall.org>
Link: https://lore.kernel.org/r/20240524163619.26001-2-daniel@iogearbox.net
Signed-off-by: Alexei Starovoitov <ast@kernel.org>

Enable reuse of logic in eth_type_trans for determining packet type.

Suggested-by: Sabrina Dubroca <sd@queasysnail.net>
Cc: stable@vger.kernel.org
Signed-off-by: Rahul Rameshbabu <rrameshbabu@nvidia.com>
Reviewed-by: Sabrina Dubroca <sd@queasysnail.net>
Link: https://lore.kernel.org/r/20240423181319.115860-3-rrameshbabu@nvidia.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Follow the advice of the Documentation/filesystems/sysfs.rst and show()
should only use sysfs_emit() or sysfs_emit_at() when formatting the
value to be returned to user space.

Signed-off-by: ye xingchen <ye.xingchen@zte.com.cn>
Reviewed-by: Leon Romanovsky <leonro@nvidia.com>
Link: https://lore.kernel.org/r/202212051918564721658@zte.com.cn
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Introduce a simple helper function to replace a common pattern.
When accessing the GRO header, we fetch the pointer from frag0,
then test its validity and fetch it from the skb when necessary.

This leads to the pattern
skb_gro_header_fast -> skb_gro_header_hard -> skb_gro_header_slow
recurring many times throughout GRO code.

This patch replaces these patterns with a single inlined function
call, improving code readability.

Signed-off-by: Richard Gobert <richardbgobert@gmail.com>
Reviewed-by: Eric Dumazet <edumazet@google.com>
Link: https://lore.kernel.org/r/20220823071034.GA56142@debian
Signed-off-by: Paolo Abeni <pabeni@redhat.com>

As noted in the original commit 685343fc3ba6 ("net: add
name_assign_type netdev attribute")

  ... when the kernel has given the interface a name using global
  device enumeration based on order of discovery (ethX, wlanY, etc)
  ... are labelled NET_NAME_ENUM.

That describes this case, so set the default for the devices here to
NET_NAME_ENUM.  Current popular network setup tools like systemd use
this only to warn if you're setting static settings on interfaces that
might change, so it is expected this only leads to better user
information, but not changing of interfaces, etc.

Signed-off-by: Ian Wienand <iwienand@redhat.com>
Link: https://lore.kernel.org/r/20220406093635.1601506-1-iwienand@redhat.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

All gro_complete() handlers are called from napi_gro_complete()
while rcu_read_lock() has been called.

There is no point stacking more rcu_read_lock()

Signed-off-by: Eric Dumazet <edumazet@google.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

All gro_receive() handlers are called from dev_gro_receive()
while rcu_read_lock() has been called.

There is no point stacking more rcu_read_lock()

Signed-off-by: Eric Dumazet <edumazet@google.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>

Commit 406f42fa0d3c ("net-next: When a bond have a massive amount
of VLANs...") introduced a rbtree for faster Ethernet address look
up. To maintain netdev->dev_addr in this tree we need to make all
the writes to it got through appropriate helpers.

There is a handful of drivers which pass netdev->dev_addr as
the destination buffer to eth_platform_get_mac_address().
Add a helper which takes a dev pointer instead, so it can call
an appropriate helper.

Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>