linux.git - Clone of https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git

Age	Commit message (Collapse)	Author	Files	Lines
2023-08-25	net: pcs: xpcs: adapt Wangxun NICs for SGMII mode	Jiawen Wu	1	-2/+3
	Wangxun NICs support the connection with SFP to RJ45 module. In this case, PCS need to be configured in SGMII mode. According to chapter 6.11.1 "SGMII Auto-Negitiation" of DesignWare Cores Ethernet PCS (version 3.20a) and custom design manual, do the following configuration when the interface mode is SGMII. 1. program VR_MII_AN_CTRL bit(3) [TX_CONFIG] = 1b (PHY side SGMII) 2. program VR_MII_AN_CTRL bit(8) [MII_CTRL] = 1b (8-bit MII) 3. program VR_MII_DIG_CTRL1 bit(0) [PHY_MODE_CTRL] = 1b Also CL37 AN in backplane configurations need to be enabled because of the special hardware design. Another thing to note is that PMA needs to be reconfigured before each CL37 AN configuration for SGMII, otherwise AN will fail, although we don't know why. On this device, CL37_ANSGM_STS (bit[4:1] of VR_MII_AN_INTR_STS) indicates the status received from remote link during the auto-negotiation, and self-clear after the auto-negotiation is complete. Meanwhile, CL37_ANCMPLT_INTR will be set to 1, to indicate CL37 AN is complete. So add another way to get the state for CL37 SGMII. Signed-off-by: Jiawen Wu <jiawenwu@trustnetic.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2023-08-25	net: pcs: xpcs: support to switch mode for Wangxun NICs	Jiawen Wu	1	-0/+208
	According to chapter 6 of DesignWare Cores Ethernet PCS (version 3.20a) and custom design manual, add a configuration flow for switching interface mode. If the interface changes, the following setting is required: 1. wait VR_XS_PCS_DIG_STS bit(4, 2) [PSEQ_STATE] = 100b (Power-Good) 2. write SR_XS_PCS_CTRL2 to select various PCS type 3. write SR_PMA_CTRL1 and/or SR_XS_PCS_CTRL1 for link speed 4. program PMA registers 5. write VR_XS_PCS_DIG_CTRL1 bit(15) [VR_RST] = 1b (Vendor-Specific Soft Reset) 6. wait for VR_XS_PCS_DIG_CTRL1 bit(15) [VR_RST] to get cleared Only 10GBASE-R/SGMII/1000BASE-X modes are planned for the current Wangxun devices. And there is a quirk for Wangxun devices to switch mode although the interface in phylink state has not changed, since PCS will change to default 10GBASE-R when the ethernet driver(txgbe) do LAN reset. Signed-off-by: Jiawen Wu <jiawenwu@trustnetic.com> Signed-off-by: David S. Miller <davem@davemloft.net>