From 0f978bfaf2600040f9826f394eb12e023bef3068 Mon Sep 17 00:00:00 2001 From: Sujith Manoharan Date: Fri, 6 Dec 2013 16:28:45 +0530 Subject: ath9k: Use a separate TX gain table for WZR-HP-G450H The Buffalo device WZR-HP-G450H uses the index 3 for TX gain, which is set to the high_power table currently. Later variants of the router use the same index, but instead refer to the low_ob_db gain table. This is not handled in the driver since there is no way to distinguish board revisions and the high_power table is used (incorrectly) for the newer variants. By default, devices based on AR9300 using the TX gain index 3 have to use the high_power table. To make sure that WZR-HP-G450H is not broken when the high_power table is updated, use a separate array based on information obtained from the platform data. The current situation where only the original variant of WZR-HP-G450H works properly stays unchanged. Signed-off-by: Sujith Manoharan Signed-off-by: John W. Linville --- include/linux/ath9k_platform.h | 2 ++ 1 file changed, 2 insertions(+) (limited to 'include/linux/ath9k_platform.h') diff --git a/include/linux/ath9k_platform.h b/include/linux/ath9k_platform.h index fcdd81bd5314..8598f8eacb20 100644 --- a/include/linux/ath9k_platform.h +++ b/include/linux/ath9k_platform.h @@ -32,6 +32,8 @@ struct ath9k_platform_data { u32 gpio_val; bool is_clk_25mhz; + bool tx_gain_buffalo; + int (*get_mac_revision)(void); int (*external_reset)(void); }; -- cgit v1.2.3