Merge tag 'mtd/changes-for-5.18' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux

Pull MTD updates from Miquel Raynal:
 "There has been a lot of activity in the MTD subsystem recently, with a
  number of SPI-NOR cleanups as well as the introduction of ECC engines
  that can be used by SPI controllers (hence a few SPI patches in here).

  Core MTD changes:
   - Replace the expert mode symbols with a single helper
   - Fix misuses of of_match_ptr()
   - Remove partid and partname debugfs files
   - tests: Fix eraseblock read speed miscalculation for lower partition
     sizes
   - TRX parser: Allow to use on MediaTek MIPS SoCs

  MTD driver changes:
   - spear_smi: use GFP_KERNEL
   - mchp48l640: Add SPI ID table
   - mchp23k256: Add SPI ID table
   - blkdevs: Avoid soft lockups with some mtd/spi devices
   - aspeed-smc: Improve probe resilience

  Hyperbus changes:
   - HBMC_AM654 should depend on ARCH_K3

  NAND core changes:
   - ECC:
      - Add infrastructure to support hardware engines
      - Add a new helper to retrieve the ECC context
      - Provide a helper to retrieve a pilelined engine device

  NAND-ECC changes:
   - Macronix ECC engine:
      - Add Macronix external ECC engine support
      - Support SPI pipelined mode
      - Make two read-only arrays static const
      - Fix compile test issue

  Raw NAND core changes:
   - Fix misuses of of_match_node()
   - Rework of_get_nand_bus_width()
   - Remove of_get_nand_on_flash_bbt() wrapper
   - Protect access to rawnand devices while in suspend
   - bindings: Document the wp-gpios property

  Rax NAND controller driver changes:
   - atmel: Fix refcount issue in atmel_nand_controller_init
   - nandsim:
      - Add NS_PAGE_BYTE_SHIFT macro to replace the repeat pattern
      - Merge repeat codes in ns_switch_state
      - Replace overflow check with kzalloc to single kcalloc
   - rockchip: Fix platform_get_irq.cocci warning
   - stm32_fmc2: Add NAND Write Protect support
   - pl353: Set the nand chip node as the flash node
   - brcmnand: Fix sparse warnings in bcma_nand
   - omap_elm: Remove redundant variable 'errors'
   - gpmi:
      - Support fast edo timings for mx28
      - Validate controller clock rate
      - Fix controller timings setting
   - brcmnand:
      - Add BCMA shim
      - BCMA controller uses command shift of 0
      - Allow platform data instantation
      - Add platform data structure for BCMA
      - Allow working without interrupts
      - Move OF operations out of brcmnand_init_cs()
      - Avoid pdev in brcmnand_init_cs()
      - Allow SoC to provide I/O operations
      - Assign soc as early as possible

  Onenand changes:
   - Check for error irq

  SPI-NAND core changes:
   - Delay a little bit the dirmap creation
   - Create direct mapping descriptors for ECC operations

  SPI-NAND driver changes:
   - macronix: Use random program load

  SPI NOR core changes:
   - Move vendor specific code out of the core into vendor drivers.
   - Unify all function and object names in the vendor modules.
   - Make setup() callback optional to improve readability.
   - Skip erase logic when the SPI_NOR_NO_ERASE flag is set at flash
     declaration.

  SPI changes:
   - Macronix SPI controller:
      - Fix the transmit path
      - Create a helper to configure the controller before an operation
      - Create a helper to ease the start of an operation
      - Add support for direct mapping
      - Add support for pipelined ECC operations
   - spi-mem:
      - Introduce a capability structure
      - Check the controller extra capabilities
      - cadence-quadspi/mxic: Provide capability structures
      - Kill the spi_mem_dtr_supports_op() helper
      - Add an ecc parameter to the spi_mem_op structure

  Binding changes:
   - Dropped mtd/cortina,gemini-flash.txt
   - Convert BCM47xx partitions to json-schema
   - Vendor prefixes: Clarify Macronix prefix
   - SPI NAND: Convert spi-nand description file to yaml
   - Raw NAND chip: Create a NAND chip description
   - Raw NAND controller:
      - Harmonize the property types
      - Fix a comment in the examples
      - Fix the reg property description
   - Describe Macronix NAND ECC engine
   - Macronix SPI controller:
      - Document the nand-ecc-engine property
      - Convert to yaml
      - The interrupt property is not mandatory"

* tag 'mtd/changes-for-5.18' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux: (104 commits)
  mtd: nand: ecc: mxic: Fix compile test issue
  mtd: nand: mxic-ecc: make two read-only arrays static const
  mtd: hyperbus: HBMC_AM654 should depend on ARCH_K3
  mtd: core: Remove partid and partname debugfs files
  dt-bindings: mtd: partitions: convert BCM47xx to the json-schema
  mtd: tests: Fix eraseblock read speed miscalculation for lower partition sizes
  mtd: rawnand: atmel: fix refcount issue in atmel_nand_controller_init
  mtd: rawnand: rockchip: fix platform_get_irq.cocci warning
  mtd: spi-nor: Skip erase logic when SPI_NOR_NO_ERASE is set
  mtd: spi-nor: renumber flags
  mtd: spi-nor: slightly change code style in spi_nor_sr_ready()
  mtd: spi-nor: spansion: rename vendor specific functions and defines
  mtd: spi-nor: spansion: convert USE_CLSR to a manufacturer flag
  mtd: spi-nor: move all spansion specifics into spansion.c
  mtd: spi-nor: spansion: slightly rework control flow in late_init()
  mtd: spi-nor: micron-st: rename vendor specific functions and defines
  mtd: spi-nor: micron-st: convert USE_FSR to a manufacturer flag
  mtd: spi-nor: move all micron-st specifics into micron-st.c
  mtd: spi-nor: xilinx: correct the debug message
  mtd: spi-nor: xilinx: rename vendor specific functions and defines
  ...

1 files changed, 49 insertions, 0 deletions

diff --git a/include/linux/mtd/nand.h b/include/linux/mtd/nand.h
index 32fc7edf65b3..c3693bb87b4c 100644
--- a/include/linux/mtd/nand.h
+++ b/include/linux/mtd/nand.h
@@ -264,11 +264,35 @@ struct nand_ecc_engine_ops {
 };
 
 /**
+ * enum nand_ecc_engine_integration - How the NAND ECC engine is integrated
+ * @NAND_ECC_ENGINE_INTEGRATION_INVALID: Invalid value
+ * @NAND_ECC_ENGINE_INTEGRATION_PIPELINED: Pipelined engine, performs on-the-fly
+ *                                         correction, does not need to copy
+ *                                         data around
+ * @NAND_ECC_ENGINE_INTEGRATION_EXTERNAL: External engine, needs to bring the
+ *                                        data into its own area before use
+ */
+enum nand_ecc_engine_integration {
+	NAND_ECC_ENGINE_INTEGRATION_INVALID,
+	NAND_ECC_ENGINE_INTEGRATION_PIPELINED,
+	NAND_ECC_ENGINE_INTEGRATION_EXTERNAL,
+};
+
+/**
  * struct nand_ecc_engine - ECC engine abstraction for NAND devices
+ * @dev: Host device
+ * @node: Private field for registration time
  * @ops: ECC engine operations
+ * @integration: How the engine is integrated with the host
+ *               (only relevant on %NAND_ECC_ENGINE_TYPE_ON_HOST engines)
+ * @priv: Private data
  */
 struct nand_ecc_engine {
+	struct device *dev;
+	struct list_head node;
 	struct nand_ecc_engine_ops *ops;
+	enum nand_ecc_engine_integration integration;
+	void *priv;
 };
 
 void of_get_nand_ecc_user_config(struct nand_device *nand);
@@ -279,8 +303,28 @@ int nand_ecc_prepare_io_req(struct nand_device *nand,
 int nand_ecc_finish_io_req(struct nand_device *nand,
 			   struct nand_page_io_req *req);
 bool nand_ecc_is_strong_enough(struct nand_device *nand);
+
+#if IS_REACHABLE(CONFIG_MTD_NAND_CORE)
+int nand_ecc_register_on_host_hw_engine(struct nand_ecc_engine *engine);
+int nand_ecc_unregister_on_host_hw_engine(struct nand_ecc_engine *engine);
+#else
+static inline int
+nand_ecc_register_on_host_hw_engine(struct nand_ecc_engine *engine)
+{
+	return -ENOTSUPP;
+}
+static inline int
+nand_ecc_unregister_on_host_hw_engine(struct nand_ecc_engine *engine)
+{
+	return -ENOTSUPP;
+}
+#endif
+
 struct nand_ecc_engine *nand_ecc_get_sw_engine(struct nand_device *nand);
 struct nand_ecc_engine *nand_ecc_get_on_die_hw_engine(struct nand_device *nand);
+struct nand_ecc_engine *nand_ecc_get_on_host_hw_engine(struct nand_device *nand);
+void nand_ecc_put_on_host_hw_engine(struct nand_device *nand);
+struct device *nand_ecc_get_engine_dev(struct device *host);
 
 #if IS_ENABLED(CONFIG_MTD_NAND_ECC_SW_HAMMING)
 struct nand_ecc_engine *nand_ecc_sw_hamming_get_engine(void);
@@ -962,6 +1006,11 @@ int nanddev_markbad(struct nand_device *nand, const struct nand_pos *pos);
 int nanddev_ecc_engine_init(struct nand_device *nand);
 void nanddev_ecc_engine_cleanup(struct nand_device *nand);
 
+static inline void *nand_to_ecc_ctx(struct nand_device *nand)
+{
+	return nand->ecc.ctx.priv;
+}
+
 /* BBT related functions */
 enum nand_bbt_block_status {
 	NAND_BBT_BLOCK_STATUS_UNKNOWN,