When smsc911x uses GPIO as the interrupt controller, and if both are
loaded as modules, we get following error:
"smsc911x: Could not allocate irq resource"
This issue is because of smsc911x using platform_get_resource to get
device tree based irq resource.
commit "
9ec36ca (of/irq: do irq resolution in platform_get_irq)" and
commit "7085a7 (drivers: platform: parse IRQ flags from resources)" add
support in platform_get_irq to resolve irq and irq_flags respectively
for both modern device tree and legacy static platform data platforms.
Modify smsc911x driver to use platform_get_irq to pick up irq resource
correctly and use irq_get_trigger_type to get the IRQ trigger flags.
Signed-off-by: Kamlakant Patel <kamlakant.patel@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
struct net_device *dev;
struct smsc911x_data *pdata;
struct smsc911x_platform_config *config = dev_get_platdata(&pdev->dev);
struct net_device *dev;
struct smsc911x_data *pdata;
struct smsc911x_platform_config *config = dev_get_platdata(&pdev->dev);
- struct resource *res, *irq_res;
- int res_size, irq_flags;
+ int res_size, irq, irq_flags;
int retval;
res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
int retval;
res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
}
res_size = resource_size(res);
}
res_size = resource_size(res);
- irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
- if (!irq_res) {
+ irq = platform_get_irq(pdev, 0);
+ if (irq <= 0) {
pr_warn("Could not allocate irq resource\n");
retval = -ENODEV;
goto out_0;
pr_warn("Could not allocate irq resource\n");
retval = -ENODEV;
goto out_0;
SET_NETDEV_DEV(dev, &pdev->dev);
pdata = netdev_priv(dev);
SET_NETDEV_DEV(dev, &pdev->dev);
pdata = netdev_priv(dev);
- dev->irq = irq_res->start;
- irq_flags = irq_res->flags & IRQF_TRIGGER_MASK;
+ dev->irq = irq;
+ irq_flags = irq_get_trigger_type(irq);
pdata->ioaddr = ioremap_nocache(res->start, res_size);
pdata->dev = dev;
pdata->ioaddr = ioremap_nocache(res->start, res_size);
pdata->dev = dev;